Honeywell / Satronic  control box are capable of controlling and monitoring medium to high performance oil, gas burners in single or two stage versions. These Burner Programmer can be used, as preferred, for multi-stage or modulating operation with burners of any nominal rating as well as in direct air heaters. Oil Gas Burner Sequence Controllers provides a safe light-up and shut-down sequence for the burner and incorporates pre-purge, pre-ignition, post ignition and lockout safety time intervals. The control box is designed for maximum safety in case of fluctuations in the voltage supply. The built in information system not only provides a continuous monitoring of the actual state of the box but also informs about the cause of a possible lockout. Different model designations identify the control boxes according to programmed times for varying national standards, or for special applications and also as Boiler Spares, Burner Spare Parts.

MMI 810 MMI 813 DLG 976 TMO 720-4 TMG 740-3 TME 780

MMI 810 Flame monitoring device for oil/ Gas Flames. The IRD810 or820 is employed to monitor the flame of an oil/gas burner. This flame monitoring device should be connected to a Satronic oil or gas burner control box.             MMI 813 The gas burner autotmatic safety control MMI813.1 controls and monitors blown gas and combined burners of any nominal thermal load, together with an air damper motor, a 2 stage operation with 1 fuel valve.             DLG 976 Gas burner safety controls and supervises, power burner for gas and dual fuel. The control box’s possible flame detectors are ionization probe, infra red flicker detector and u.v. flame sensor.             TMO 720-4 The TMO 720-4 burner control box is for forced draught burners with a capacity of over 30 kg/hour in intermittent operation 1 or 2 stage, Flame detector for this controller are photo-resistor FZ 711S and infrared flicker detector IRD 1010.             TMG 740-3 The TMG 740-3 burner control box is capable of controlling and monitoring medium to high performance forced draught and dual fuel oil/gas burners in single ot two stage versions.             TME 780 The TME780 is capable of controlling and monitoring oil/ Gas and combi burners of unlimited capacity suitable for continous operation. The possible flame detectors are FZ 780 photocell, Ionisation Probe and UV 780 sensor.